CTEK MXS 7000 - Manual (Page 6)

MAINTENANCE
The charger is maintenance free. Note that disassembly of the charger is not permitted and
will void the warranty. If the power cord is damaged, the charger must be left to the reseller for
maintenance. The case can be cleaned with a soft damp cloth and mild cleanser. The charger
should be disconnected from the power supply while cleaning.
EQUIPMENT
MULTI XS 7000 is delivered with a set of battery cables with battery pole clamps and a set of
battery cables with eyelet terminals.
WARRANTY
CTEK SWEDEN AB, Rostugnsvägen 3, 776 70 VIKMANSHYTTAN, SWEDEN provides a lim-
ited warranty to the original purchaser of this product. This limited warranty is not transferable.
The unit is warranted against defective workmanship or materials for
5 years from the date of
purchase. The customer must return the product together with the original purchase receipt to
the place of purchase. This warranty is void if the unit is handled carelessly, opened or repaired
by anyone other than CTEK SWEDEN AB or its authorized representative. CTEK SWEDEN AB
makes no warranty other than this limited warranty and expressly excludes any implied warranty
including any warranty for consequential damages. This is the only expressed limited warranty
and CTEK SWEDEN AB neither assumes nor authorizes anyone to assume or make any other
obligation towards the product other than his limited warranty.
TECHNICAL SPECIFICATION
Model 1007
Voltage AC 170–260VAC, 50–60Hz
Back current drain* < 1mA
Voltage Charging Voltage Nominal: 12V
13.6V; 14.4V; 14.7V or 15.7V
Ripple** Max 150mV rms, max 0.3 A (=4%)
Current 7A max
Ambient Temperature -20°C to +50°C, power is reduced automatically at
increased ambient temperature.
Cooling Natural convection.
Charging cycle MULTI XS 7000 is a multi stage fully automatic charger
Type of batteries All types of 12 V lead-acid batteries (Wet, MF, AGM and GEL).
Battery Capacity 14–225Ah
Dimensions 191 x 89 x 48 mm (L x W x H)
Insulation IP65***
Weight 0.8kg
*) Back Current Drain is what the charger uses to drain the battery if the power cord is
disconnected.
**) Quality of the current and voltage are very important. High current ripple heats up the
battery and makes the positive electrode age prematurely. High voltage ripple could harm
other equipment connected to the battery. MULTI XS 7000 produces a high quality current and
voltage with very low ripple.
***) If the electrical plug is of the flat euro connector type, the battery charger has insulation
class IP63, except in Switzerland where IP65 is valid.