Ariens SNO-THRO 924333 - 1024 - Manual (Page 10)

GB - 10
7. Install wing nut and bolt removed in step 2 onto
shift rod and tighten hardware.
Install Discharge Chute and Crank
(119,120,333,334)
1. Grease discharge chute ring on blower housing
(if not already greased).
2. Slide chute ring under front clip on blower
housing and put chute on housing.
3. Remove mounting hardware from top of engine.
4. Secure chute by fastening chute strap to engine
with hardware just removed.
5. Slide chute crank rod through bracket under
handlebar and through hole in panel.
6. Align chute crank rod with the universal joint on
chute and fasten with spring clip.
Install Discharge Chute - Electric Rotation
(502,503)
1. Remove chute motor cover.
2. Remove the six (6) nuts from ring gear (Figure 6).
3. Remove two (2) half rings.
4. Position Discharge Chute over threaded studs
with the chute opening facing the electric motor.
5. Replace the half rings.
6. Replace the six (6) nuts and tighten to 120 in. lbs.
torque.
7. Replace chute motor cover.
Connect Battery (333,334,502,503)
1. Remove wing nuts from battery cover.
2. Install wire lead to battery terminal.
3. Install battery cover and tighten wing nuts.
Deflector Remote (502,503,119)
1. Slide cable end through hole on bracket on left
side of chute.
2. Attach cable eye to stud on deflector. Hold in
place with flat washer and e-ring.
3. Check deflector travel. Adjust nut on cable end
under handlebar to obtain full travel.
Check Attachment Clutch
Clutch cable spring should expand approximately 3/8”
(9mm) beyond free state when clutch is engaged.
1. When clutch is disengaged, lower end of clutch
arm should return to its maximum down position,
with slight amount of slack in control cable.
2. If proper spring extension is not obtained, adjust
Attachment Idler per Service and Adjustments .
Check Function of Dual Handle Interlock
Without the engine running, press down (engage) both
clutch levers. Release attachment clutch lever.
Attachment clutch should remain engaged until traction
clutch lever is released, then both clutches
must
disengage.
Check Tire Pressure
Check tire pressure and adjust to 14 PSI (96.5 kNm
2
).
Check Auger Gearcase Oil
Check oil level in auger gearcase (see Service and
Adjustments ).
Check Engine Crankcase Oil
IMPORTANT: Engines on all Sno-Thro models are
shipped with oil in crankcase. Refer to Engine Manual
for detailed instructions.
Fill Engine Fuel Tank
Refer to Engine Manual for proper fuel type and tank
capacity.
1
2
3
1. Ring Gear Nuts
2. Half Rings
3. Discharge Chute
Figure 6
OS1930
Figure 7
1. Cable Eye
2. Flat Washer and E-Ring
3. Deflector Cable
OS1981
1
2
3