Alpine SEC-150R - Manual (Page 52)

English
52
1. Place the remote control transmitter on a
flat surface with the buttons facing down.
Remove the battery case screws using a
#1 sized Phillips screwdriver.
2. While holding the remote control with the
buttons facing down, gently remove the
bottom cover.
3. Remove the old battery and insert a new
12V alkaline battery. Make sure the
battery polarity is correct.
4. Replace the bottom cover.
5. Tighten the screws. Be careful not to
overtighten.
Remote Control
Battery Replacement
Crystal
3/26/01