beautypg.com

Comprehensive CSW-HD1616 User Manual

Page 14

background image

HDMI Matrix Switcher

11

Recall[Y].

Recall the preset command [Y].

Clear[Y].

Clear the preset command [Y].

EDIDMInit.

Recover the factory default EDID data.

EDIDM[X]B[Y].

Manually EDID management. Copy the EDID data of output[X] to

the input[Y].

PWON.

Normal working status.

PWOFF.

Stand by status.

Remarks: Dot is one part of the RS232 code!

Note:

1. [x1], [x2], [x3] and [x4] are the symbols of input or output channels ranged according to the

model of the matrix switcher. If the symbols exceed the effective range, it would be taken as a

wrong command.

2. In above commands, “[”and “]” are symbols for easy reading and do not need to be typed in

actual operation.

3. Please remember to end the commands with the ending symbols “.” and “;”.

Detail Examples:

1

Transfer signals from an input channel to all output channels: [x1]All.

Example: To transfer signals from the input channel No.3 to all output channels. Run Command:

“3All.”

2

Transfer all input signals to the corresponding output channels respectively: All#.

Example: If this command is carried out, the status will be: 1->1, 2->2, 3->3, 4->4……16->16.

3

Switch off all the output channels: All$.

Example: After running this command, there will be no signals on all the output channels.

4

Check the version of the firmware:

/^Version;

To check the version of the firmware.

5

Switch off the detail feedback command from the COM port: /:MessageOff;

Switch off the detail feedback information from the COM port. But, it will leave the “switch OK” as

the feedback, when you switch the matrix.

6

Switch on the detail feedback command from the COM port: /:MessageOn;

Switch on the detail feedback information from the COM port. it will show the detail switch

information when it switch. Example: when switch 1->2 for Audio, it will feedback “A0102”.

7

Transfer signals from an input channel to the corresponding output channel: [x]#.

Example: To transfer signals from the input channel No.5 to the output channel No.5. Run

Command: “5#.”

8

Switch off an output channel: [x]$.

Example: To switch off the output channel No.5. Run Command: “5$.”

9

Switch both video and audio signals synchronously: [x1] B[x2].

Example: To transfer both the video and the audio signals from the input channel No.12 to the

output channel No.12,13,15. Run Command: “12B12,13,15.”

10

Transfer both the video and audio signals from input channel [x1] to output group [g]:

[x1]P[g].