CognitiveTPG A799 - Manual (Page 7)

7
TPG-ETHSUG Rev. A 11/07
Ethernet Interface Setup Guide
DHCP (auto-configuration)
ASCII US BS BS n1
Hexadecimal 1F 08 08 n1
Decimal 1 8 8 n1
n1 = 0: disabled
n1 = 1: enabled
Default: enabled
Enables or disables the use of DHCP at power-up to obtain an IP address. If no address is found within two minutes,
DHCP obtains the default IP address.
Inactivity timeout
ASCII US BS HT n1
Hexadecimal 1F 08 09 n1
Decimal 1 8 9 n1
n1 = 0: disabled
n1 = 1: enabled
Default: enabled
Enables or disables resetting of open TCP ports after five (5) minutes inactivity.
Keep alive pings
ASCII US BS LF n1
Hexadecimal 1F 08 0A n1
Decimal 1 8 10 n1
n1 = 0: disabled
n1 = 1: enabled
Default: enabled
Enables or disables sending of the keep alive pings (self arps). Keep alive pings may be required for use with such things
as smart hubs; to remind the smart hub to which port a printer is connected.
If enabled, self arps are sent every ten (10) minutes.
Buffer full handling
ASCII US BS VT n1
Hexadecimal 1F 08 0B n1
Decimal 1 8 10 n1
n1 = 0: Do not allow overflow
n1 = 1: Allow overflow when printer in error
Default: Overflow prevented
This allows overflowing communication buffer when printer is in an error state. This will allow processing of real time
commands. It is not recommended to allow overflow.