Cleveland Motion Controls ULTRA SERIES SLIM CELL TRANSDUCER REV AA - Manual (Page 5)

AO-70263 R EV AA U LTRA S ERIES S LIM C ELL T RANSDUCER
P AGE 5 OF 18
1 I
MPORTANT
I
NFORMATION
1.1 O
RDER
N
UMBERS
Use the following illustration to configure an ordering number when purchasing a Slim Cell Ultra Series Load
Cell:
RS 0.750 BF UltraSLM 1 25
Load Cell
Rating
Roller
Shaft
Diameter
Load Cell
Body Size
Load Cell Back
Plate
Roller Shaft
Type
To order the optional mounting bracket, use the part numbers listed in the table below:
If you need a mounting bracket for: Then order part number:
Slim Cell Size 1 (UltraSLM 1) SLM BR 1
Slim Cell Size 2 (UltraSLM 2) SLC BR2
1.2 C ONTACT I NFORMATION AND S ERVICE A SSISTANCE
For service assistance, have the following information available:
• Type of Slim Cell Transducer
• Maximum Working Force
• Purchase Order Number
To contact us, visit our website at www.cmccontrols.com or use the following numbers:
Phone: 216.524.8800
Fax:
216.642.5155
Disassembly by improperly trained personnel may result in additional damage to these units. Should repairs
be required or for warranty repairs, contact the Customer Service Department for a return authorization
number before returning the units.
1.3 R
ECEIVING AND
U
NPACKING
After receiving the Ultra Slim Cell Transducer you should:
• Carefully unpack and handle the equipment
• Compare the received shipment with the packing list
• Report any damage to the carrier and your CMC representative
• Store equipment that will not be used in a clean, dry location
• Take appropriate precautions to prevent moisture, dust and dirt from accumulating in
storage and installation areas
10 lb (45n) UltraSLM 1 Blank/Flush BF Rotating
(Live) RS
Inches 25 lb (110N) UltraSLM 2 Blank/Pilot BP
0.625 50 lb (225 N) Hole/ Flush HF
Hole/Pilot HP
0.750 100 lb (450 N) Refer to
table in
Section 2.1.1 Stationary
1.000 250 lb (1100 N) (Dead) SS
1.250 500 lb (2250 N) Refer to table in
Section 2.2.5
1000 lb (4500 N) 1.500
1.750
Millimeters
15
20
25
30
35
40