Autostart AS-2510 TW User Manual

Page 13

P. 13

User Guide

AS-2510 TW

Horn Chirp Timing
The duration of the chirps can be adjusted at installation (from 5 to 200 ms).

Flashing LED
The user may decide to turn on or off LED flashing at any moment. To do so, simultaneously press
the

TRUNK

and

LOCK

buttons on the transmitter:

x Flashing LED

: the L.E.D. will flash at all times (either under active arming or under passive

arming) to indicate that the Starter Kill is active.

x Active Arming: the LED will flash normally.
x Passive Arming: the LED will flash at a faster rate during the countdown preceding the

activation of the Starter Kill. Once the Remote Car Starter

is armed, the LED will flash at a slower rate.

x In Valet Mode: the LED will remain lit without flashing.

x Flashing LED

OFF

: the LED will not flash even when the Remote Car Starter is armed (either

under active or passive arming). Nevertheless, if the Remote Car Starter enters Valet Mode, the
LED will still remain lit without flashing as long as the ignition is off.

Safe Start
If this feature is enabled, the user must press the

START

button 2 times within 3 seconds to remote-

start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing with the
transmitter.
If Swap Start Mode is selected, to remote-start your vehicle press

LOCK

and

UNLOCK

simultaneously. The

AUX 2

output can be activated by pressing the

START

button.

Home Valet

If this feature is installed, the user will have the possibility to remotely set the vehicle to a no-
remote-start mode. See Home Valet section, earlier in this Guide, for full instructions.

Ignition-controlled Door Locks
This is an added security feature. If your Remote Car Starter was installed with the Ignition-
Controlled Door Locks option, the doors will automatically be locked as soon as the ignition key is
turned to the

IGNITION ON (RUN)

position while the brakes are pressed. When the key is turned to the

OFF

position, the doors will automatically be unlocked.

Ignition Re-lock
On Remote Car Starters of this series, when Ignition-controlled Door Locks are enabled and the
ignition key is in the

IGNITION ON (RUN)

position, should any door be unlocked and opened, all doors

will be relocked next time the brake pedal is pressed.

Secure Lock
Before it can remote-start your vehicle, the Remote Car Starter must first disarm the factory
security system. The Secure Lock feature may be required on certain vehicle models with factory
security systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start,
Secure Lock will relock your doors as soon as the vehicle has started. Once the engine run cycle
ends, Secure Lock will rearm your factory security system.

Turbo Mode
When left in Turbo Mode, the Remote Car Starter will keep the engine running for 60 seconds
before shutting it down. This is to allow a turbocharger to idle down after the user leaves the
vehicle. See Turbo Mode section earlier in this Guide.