beautypg.com

Autostart AS-2510 TW User Manual

Page 11

background image

Remote Valet Mode
This feature will allow you to remotely put your system into Valet Mode by using the transmitter
instead of the Valet button as above.

Getting i n t o Valet Mode

x Hold the

UNLOCK

and

START/STOP

buttons simultaneously for 3 seconds.

x The Parking Lights will flash 3 times.
The Transmitter will BEEP once and will display the

icon; the LED will remain on solid.

Getting o u t of Valet Mode

x Hold the

UNLOCK

and

START/STOP

buttons simultaneously for 3 seconds.

x The Parking Lights will flash 2 times.
The Transmitter will BEEP once and the

icon will disappear; the LED will turn off.

Note:

With the Remote Valet activated, the remote starter function will be disabled.

Panic Mode

Note: Panic Mode can only be activated if the horn has been adequately configured by your
installer.

In an emergency situation, you can activate Panic Mode using the

LOCK

or

UNLOCK

button. This will:

x shut down the engine,
x unlock the doors (with the

UNLOCK

button)

x or lock the doors (with the

LOCK

button),

x disarm the Starter Kill and
x activate the horn for 30 sec.

Note: See the description of the Starter Kill option later in this Guide.

To activate Panic Mode:

x Press and hold the

UNLOCK

button for approximately 3 sec. until the sound signal starts

and the parking lights flash: this will unlock the doors before the sound signal starts.

x Or press and hold the

LOCK

button for approximately 3 seconds until the sound signal

starts and the parking lights flash: this will lock the doors before the sound signal starts.

Panic Mode will automatically shut down after 30 sec.

Note

: To stop Panic Mode before the end of its delay, press the

LOCK

or

UNLOCK

button until

the sound signal stops.

Quick Lockout

TM

For fast protection in emergency situations, the system will

LOCK

all doors when you press the

brake pedal while you hear the sound signal. (Quick Lockout is only available when Panic
Mode
has been set off.)

Cold Weather Mode
When Cold Weather Mode is active, the engine starts every 2 hours and runs for 4 minutes (or for
9 or 20 minutes with diesel engines). Cold Weather Mode automatically ends after 24 hours.

To enter Cold Weather Mode:

x Press and hold the

START/STOP

button for 3 seconds

... until the parking lights flash three times.

To exit Cold Weather Mode, do any one of the following actions:

x Open the hood.
x Start the engine by remote.
x Turn the ignition key to the

IGNITION ON (RUN)

position.

x Press and hold the

START/STOP

button for 3 sec. (the parking lights will flash once).

P. 11

User Guide

AS-2510 TW