INSTEON Smoke Bridge (2982-222) Manual - Manual (Page 7)

Page 7 of 14 2982-222 - Rev: 1/21/2014 8:34 AM
Remove Smoke Bridge as a Controller of Multiple Responders
1) Press and hold Smoke Bridge set button until it beeps
LED will start blinking green
2) Press and hold Smoke Bridge set button until it beeps again
LED will start blinking red
3) Tap Smoke Bridge set button
LED will start double-blinking red
4) For each responder you are removing:
a. Press and hold Set button until it double-beeps
5) Tap Smoke Bridge set button
Smoke Bridge will beep and LED will stop blinking
6) To test, first change the responder to a different state then the desired state
7) Test by tapping Smoke Bridge set button
The Set button will cycle through the following notifications with a brief delay between each
- Smoke detected
- Carbon Monoxide (CO) detected
- Low Battery detected
- Error
- All Clear
Smoke Bridge LED will blink red during these steps
~15 seconds after it sends the All Clear command, it will turn solid green
Responder will not respond