Asus A7V133-M - Manual (Page 17)

ASUS A7V133-M User’s Manual 17
3. HARDWARE SETUP
3. H/W SETUP
Motherboard Settings
1) Jumper Setting (JEN)
This jumper is factory set for the default [1-2]. This default enables Jumper
mode. The default setting allows changes to frequencies to be made with the
DIP switches. Note that the position of this jumper must not be changed.
Setting JEN
Jumper Mode [1-2] (default)
A7V133-M JumperFree™ Setting
Jumper Mode
1 2
JEN
A7V133-M
(Default)
Motherboard Features Settings (DIP Switches - SW1)
The motherboard’s onboard functions are adjusted through the DIP switches. The
white block represents the switch’s position. The example below shows all the
switches in the OFF position.
1. Frequency Selection
2. Frequency Selection
3. Frequency Selection
4. Frequency Selection
5. Frequency Selection
A7V133-M DIP Switches
SW1
O N
4
3
2
1
5
A7V133-M