Autostart AS-1535 SH User Manual

Page 7

AS-1535 SH Installation Guide P.7

WHITE /

ORANGE

(–) Starter

Kill output

The unit is equipped with a selectable passive- or active-arming
Starter Kill circuit that will immobilize the vehicle when the system is
armed. This wire will provide a constant 500-mA negative output when
the system is armed (locked by remote) or if remote started. This wire
should be connected to a Single Pole Double-Throw Relay (This wire
will connect to Pin 85, on the Relay, and Pin 86 will be connected to the
Ignition wire).
A second benefit of the Starter Kill is the Anti-Grind feature. When the
vehicle has been remote started the Anti-Grind prevents the starter
motor from re-engaging when the ignition key is inserted in the Ignition
switch and accidentally turned to the

CRANK

position (The Starter Kill

output becomes active during remote starts).

ORANGE
(–) AUX 2

Output

Negative 500mA output. Can be programmed for one of the following
three options:
(1)

Constant while the

LOCK

and

UNLOCK

buttons are pressed + 1 sec

after release of the buttons.

(2)

LOCK + UNLOCK

toggles

ON / OFF

. (Max.30 sec)

(3)

LOCK + UNLOCK

toggles

ON / OFF

. (Max.60 sec)

(4)

Priority Door Access (2

UNLOCK

press)

PURPLE

(-) External

Trigger

The External Trigger wire can be used for remote-starting the vehicle
with an external device. When the vehicle is running, triggering this
input will activate Idle Mode. The External Trigger wire can also be used
to operate as a negative trigger with the Trunk Pin-switch, the Key
Sense wire or the Door Pin-switch:

Option 1 Connects to Negative Trunk Pin. When this wire is

programmed for

TRUNK PIN

, pressing

TRUNK

will activate a 1-second

DISARM

output. If ground (-) is detected on the

TRUNK PIN

(the Trunk has

been opened), an

ARM

pulse will be sent 5 seconds after the Trunk is

closes. An

ARM

pulse will be sent 4 seconds after the

TRUNK

button is

pressed if the Trunk pin state is unchanged (The Trunk was unopened).

DISARM

is sent only if the system was previously locked and armed. If

Secure Lock is enabled,

UNLOCK

pulse(s) will be sent with

DISARM, a

LOCK

pulse and a

REARM

pulse will be sent when the Trunk is closed

or if the Trunk was left closed.

Option 2 (Default: Engine Start/Stop): The first Ground (-) pulse on
this input will start the Engine, the second Ground (-) pulse on this input
will stop the Engine.