Display description, Startup, Set the power to on – Hach-Lange H170 User Manual User Manual
Page 10: Configure the meter

Display description
shows measurement modes and values, data connection and storage options, battery
status, temperature values, stabilization lock and connection statuses shown on the display.
Figure 5 Display
1 Setup mode
7 Measurement mode
2 Temperature and data values
8 Measurement units
3 Measured value
9 Automatic Temperature Compensation (ATC) value
(pH, conductivity, TDS or salinity)
4 Stabilization lock
10 Data storage memory location
5 Hold indicator
11 Temperature unit
6 ISFET probe indicator
12 Low battery indicator
Startup
Set the power to on
Push the power button to set the power to on or off. Make sure that the power supply (AC power or
battery power) is correctly installed.
Configure the meter
Complete the operations in order:
1. Set the power to on.
2. Push SETUP to put the meter in setup mode.
3. Use the arrow keys to select an option, then push ENTER:
10 English