Hach-Lange SI794 I User Manual - Manual (Page 78)

78
Calibration by input of cell factor
Input of cell factor with simultaneous display of conductivity and
temperature (without temperature compensation)
Display Action Remark
Enter cell factor:
Select position using 4 key,
edit number using5 key.
Conductivity and temperature
are alternately displayed dur-
ing the input (lower display).
Press enter to confirm entry.
Press cal key, enter code: 1100.
Select position using 4,
edit number using5,
press enter to proceed.
Ready for calibration
Remove and clean sensor
If an invalid code is
entered, the trans-
mitter returns to
measuring mode.
The entered cell factor and
zero point are displayed.
Press enter to confirm.
Display (3 sec)
Transmitter in Hold
mode, measured
value frozen.
Sensoface inactive.