Hach-Lange SI794 I User Manual - Manual (Page 37)

2200 SIE
(2200 SIE,
8398 PM,
3700 GLI,
Other)
37
Note: Characters represented in gray are blinking and can be edited.
Code Display Action Choices
o1 .
Select configuration
(Press conf.)
For parameter set 1:
Enter passcode “1200”
Select position using 4 arrow
key and edit number using 5
key. When the display reads
“1200”, press enter to confirm.)
For parameter set 2:
Enter passcode “1288”
Select position using 4 arrow
key and edit number using 5
key. When the display reads
“1288”, press enter to confirm.)
The transmitter is in the HOLD
mode (HOLD icon is active).
Select sensor*: Select using 4 key.
Press enter to proceed.
Note:
After each sensor selection the
nominal cell factor of the sensor
is stored. To adjust the cell factor
to the transmitter, calibrate the
sensor afterwards!
After correct input a
welcome text (CONF) is
displayed for approx. 3 sec
After correct input a
welcome text (CONF) is
displayed for approx. 3 sec
*) These parameters are only edited in parameter set 1.
They are valid for both parameter sets.