Hydrotech Precision-PWS 8-8 OWNERS GUIDE - Manual (Page 37)

37
1. Make sure the water distiller is cool before starting.
Water Distiller Head Steam Sterilization Diagram
2. Refer to the Water Distiller Head Steam Sterilization Diagram
above. Lift the front corner of the water distiller head.
3. Remove the charcoal filter.
4. Install the sterilization tube. Place the sterilization tube on the 3/8”
stainless steel filter inlet tube on the bottom of the water distiller
head.
5. Place the other end of the steam sterilization tube into a container
as it will drip water and steam.
Steam Sterilization of Water Distiller Head
NOTE: If Water Distiller is filled manually, fill the boiling tank with water to
the bottom of the water gauge pin.
BULKHEAD, 3/8"JG
(INSIDE DISTILLER)
STERILIZATION TUBE
3/8OD X 1-1/2"
SS TUBE
BULKHEAD,3/8"JG