Master programming mode – Hydrotech 6700 XTR Valve Upflow Automatic Water Softeners Service Manual User Manual

Page 13

Page 13

Master Programming Mode

CAUTION: Before entering Master Programming, please contact your local professional water dealer.

Regenerant Flow

This program step selects how the regenerant flows through the tank (must match cam). The selections

available will vary depending on the previously chosen valve model..

— Press the Up or Down buttons to adjust this value.

— Press the Extra Cycle button..

Display Format

This program step selects the display format..

— Press the Up or Down buttons to adjust this value..

— Press the Extra Cycle button..

Unit Capacity

This program step selects the timer’s total capacity of hardness that can be removed..

— Press the Shift button to select the digit you want to modify..

— Press the Up or Down buttons to adjust this value..

— Press the Extra Cycle button..

Feed Water (Hardness)

This program step is used to set the feed water hardness. The system will automatically calculate volume

remaining based on the unit capacity, capacity safety factor, and feed water hardness entered..

— Press the Shift button to select the digit you want to modify..

— Press the Up or Down buttons to adjust this value..

— Press the Extra Cycle button..

NOTE: Feed Water Hardness will not be shown in Volume Override or Time Clock system types