Hellwig Sway Bar 7891 - Manual (Page 3)

15. Tighten frame bracket U-bolts to 50 ft-lb..
16. Tighten end link clevis bolts to 35 ft-lb.
17. Tighten axle U-bolts to 60 ft-lb. Place second nut on U-bolt and tighten against primary nut to lock in place.
18. Recheck your installation, looking for clearance on any undercarriage components, such as gas lines, exhaust pipes, brake
lines, wiring, differential cover, etc.
19. Drive vehicle for a few miles, then recheck for position and tightness, readjust and retorque as needed. Then recheck
periodically thereafter.
ATTENTION INSTALLER: PLEASE MAKE SURE CUSTOMER RECEIVES THIS INSTRUCTION SHEET,
ALL IMPORTANT NOTE CARDS, WARNING CARDS AND THE WARRANTY
FORM
559-734-7451 800-367-5480 FAX 559-734-7460
Passenger Side
Mark heat shield for .281” hole
to attach heat shield to offset
bracket with 1/4” bolt and nut.
5
7891(R-7891) 07/09/10