Hellwig Sway Bar 7722 - Manual (Page 2)

4. Swing the sway bar arms up until they are parallel to the ground and then assemble the end links fol-
lowing the diagram above and Photo 3.
5. Make sure the sway bar is centered and then tighten the end link bolt until the bushings just start to
bulge. Tightening it beyond this point could cause damage to the bushings.
6. Torque the bolts holding the U-plate on the frame to factory spec.
7. Bounce the vehicle with the wheel turned full lock left and right checking for clearance on all
under carriage components: fuel tank, shocks, exhaust, differential, brake and fuel lines, etc.
8. Test drive the vehicle and recheck all clearances and the installation alignment. Adjust as needed.
Re-check your installation after one week of driving and periodically on a regular basis.
ATTENTION INSTALLER: PLEASE MAKE SURE CUSTOMER RECEIVES THIS INSTRUCTION
SHEET, ALL IMPORTANT NOTE CARDS, WARNING CARDS AND THE WARRANTY FORM
559-734-7451 800-367-5480 FAX 559-734-7460
7722 (R-7722) 07/02/2012
2
3