Hellwig Sway Bar 7722 User Manual
Installation instructions front sway bar

7722 (R-7722) 07/02/2012
SAFETY
: BEFORE BEGINNING INSTALLATION BE SURE TO SET THE PARKING BRAKE AND CHOCK THE
WHEELS.
NOTE:
TO EASE INSTALLATION AND PROPERLY ADJUST THE BAR, THE WEIGHT OF THE VEHICLE MUST
BE ON THE SUSPENSION AS IF DRIVING DOWN THE ROAD. DO NOT RAISE THE VEHICLE BY THE FRAME.
NOTE:
THIS UNIT IS DESIGNED TO MOUNT IN THE FACTORY LOCATION
TORQUE TABLE
Bolt Size 3/8”— 35 ft lbs * Bolt Size 7/16”— 45 ft lbs* Bolt Size 1/2”—75 ft lbs *Bolt Size 9/16”— 90 ft lbs
1. Remove factory sway bar and end links. Keep the factory
hardware since some of it will be reused.
2. Lubricate the insides of the D-shaped polyurethane bushings
and place them on the Hellwig sway bar. Then place the U-
plates over the bushings.
3. Bolt the U-plates to the underside of the frame in the stock
location using the factory bolts as shown in Photo 2. Leave
loose at this time.
INSTALLATION INSTRUCTIONS
Front Sway Bar
Thank you for purchasing a quality Hellwig Product.
PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION
559-734-7451 800-367-5480 FAX 559-734-7460
1
2