beautypg.com

Driver’s side passenger side – Hellwig Sway Bar 7652 User Manual

Page 2

background image

7652 (R-652) 12/29/04

4. Locate existing spare tire crossmember on vehicle frame. Place square U-bolt over the frame rail in front of the crossmem-

ber with legs of the U-bolt pointing downward.

5. Insert the legs of the U-bolt into slotted holes of the frame brackets. Using 1/2” locknuts and washers, install the frame

bracket with the centered clevis on the driver side of vehicle as shown in photos. Install the frame bracket with the offset
clevis on passenger side of vehicle as shown in photos. LEAVE LOOSE for adjustment later. ( FINAL TIGHTENING
ON FRAME U-BOLTS TORQUE TO 40 FT. LBS. )

6. Insert hourglass bushing and sleeve into end link assembly. Lubricate the bushing and sleeve to ease assembly.
7. Attach end links to clevis on frame bracket as shown using the 7/16 x 2 1/4” bolts. LEAVE LOOSE for adjustment later.
8. Raise bar ends upward to be level with the frame and attach end links to sway bar ends as shown in photos using the hard-

ware provided. Use the 1/2” lock nut on the end of the end link assembly.

9. Align bar from side to side through the D-bushings to be as centered as possible. Rotate bar front to rear by rotating the U-

Bolts on the axle. Adjust frame brackets so that the end-links are straight up and down as possible. Be sure the bar does
not contact the differential, shocks, or leaf springs.

10. Torque all of the mounting hardware to the specified rates. Bounce vehicle, checking for clearance on all undercarriage

components, ie: exhaust, shocks, fuel lines, brake lines, etc. Recheck installation periodically on a regular basis.

ATTENTION INSTALLER: PLEASE MAKE SURE CUSTOMER RECEIVES THIS INSTRUCTION

SHEET,ALL IMPORTANT NOTE CARDS, WARNING CARDS AND THE

WARRANTY FORM

Driver’s Side

Passenger Side

559-734-7451 800-367-5480 FAX 559-734-7460