Hellwig Sway Bar 5803 - Manual (Page 2)

559-734-7451 800-367-5480 FAX 559-734-7460
1. If equipped, remove factory sway bar and attach new sway bar using factory hardware.
2. If not equipped with factory rear sway bar, disconnect rear shock absorbers and lay out
holes per drilling diagram above. Locate the first hole 10 inches from the center of the
rear control arm bushing and 1.06 inches above the bottom of the control arm. See photo
(3) Locate the second hole 5.63 inches rearward from the first hole. Check location of
holes using slotted holes in control arm insert as a guide. When satisfied with the loca-
tion of the holes, drill qty 2 .391” diameter holes through each wall of the lower control
arm. Make sure the holes are square to the control arm.
3. Place 1/2” X 1-1/2” bolts in control arm insert and place insert inside lower control arm
as shown in photo (4). Align slotted holes in insert with holes drilled in step 2.
Control Arm Drilling Diagram
3 4
5803 ( R-5803 ) 02/15/07