Hellwig Air 6111 - Manual (Page 7)

10. Check your installation to ensure
that all fasteners are tight and that the
assembly and all fasteners clear brake
and fuel lines, emergency brake ca-
bles, fuel tanks, wiring harnesses, etc.
Make sure that heat shields are posi-
tioned for maximum protection of air
spring.
9. Attach brake hose bracket to brake relocation bracket as shown using 3/8X1”
bolts, washers and locknuts. Tighten bolts to 20-25 ft-lb.
Reposition brake lines
as required to avoid any contact with shock absorber. Note location of brake
hoses, electrical lines or any other component that may contact air spring assembly
and reposition as required.
559-734-7451 800-367-5480 FAX 559-734-7460
10a
Single Brake Line does
not require relocation
Brake Relocation Bracket
3/8X1” Bolt
9b
6111 ( R-6111) 03/01/12
Dual Brake Line requires relocation
Brake hose bracket
Axle Vent