GxT Ferret 925 Amp Probe - Manual (Page 2)

Introduction
The Probe is a clamp-on AC/DC current probe for use with common digital
multimeters and labscopes. It has been designed and tested according to IEC
Publication 1010-2-032 (1994, 12) (Overvoltage Category III), Safety Requirements
for Hand-help Current Clamps for Electrical Measurement and Test, the EMC
Directive (EN 50081-1 and EN 50082-1). Designed to Protection Class II, Double
or reinforced insulation requirements of UL 3111, CAN/CSA C22.2 No. 1010.1-
92, ISA-DC82, and IEC 1010-2-032.
Specifications
Current Ranges: 0-1 to 400A AC/DC and 1A to 1000A dc/ac
Output Signals: 1mV per Amp AC/DC in the 400 Amp range
0.1mV per Amp AC/DC in the 1000 Amp range
Accuracy: (DC to 400Hz)
±
(2% of reading + 5)
Working Voltage: 600V AC/DC rms
Common Mode Voltage: 42V DC or 30V AC
Storage Temperature: -20
°
C to 60
°
C (-4
°
F to 140
°
F)
Operating Temperature: 0
°
C to 45
°
C (32
°
F to 95
°
F)
Relative Humidity: 0% to 80% (0
°
C to 35
°
C; 32
°
F to 113
°
F)
0% to 70% (35
°
C to 45
°
C; 95
°
F to 113
°
F)
Battery Type: 9V, NEDA 1604 or IEC 6LR61
Battery Life: 200 Hours typical (alkaline)
Max. Conductor Size: 1 Conductor 51mm (2.00 inch)
2 Conductor 25mm (.98 inch)
Maximum Jaw Opening: 52mm (2.04 inc.)
Output Cable: 1.6 meters (63 inches)
Dimensions: 205 x 97 x 44mm (8.07 x 3,82 x 1.73 in.)
Weight: 410g (14.5 oz.)
Compatibility
The Probe is compatible with any 4000 count millivolt measuring device that has
the following features:
• Range and resolution capable of displaying millivolts with a 1 millivolt resolution
for the 400 Amp range, and a resolution of 0.1 Millivolt for the 1000 Amp
range.
• Accepts standard safety-shrouded plugs or a banana plug.
• Input impedance of greater than or equal to 10M
Ω