ELRO DWH SERIES VIDEO SECURITY SYSTEM - Manual (Page 10)

AC Power
Connection
Antenna Power
Pull-Out Stand
SD slot
QUICK START GUIDE
For further details on the installation of the camera bracket and fixings
please refer to page14.
Set Up the Camera
Set Up the Wireless Touch Screen Monitor
1. Flip out the stand, extend the antenna, connect AC/DC adapter to the
input on the side of the monitor.
2. Press and hold the POWER button on the top of the monitor for 3 - 4
seconds to power it up.
3. The receiver displays Welcome Screen for a few seconds and then
transitions to the LIVE view.
4. Place the SD card into the SD card slot located on the side of the
monitor.
Note:
The screen remains dark until the cameras is powered up.
10
Screw the camera antenna clockwise
onto the back of the camera
Screw the camera bracket clockwise onto
the lower body of the camera.
If the camera is to be installed to the ceiling,
screw the camera bracket clockwise onto
the upper body of the camera.
To Touch Screen Monitor
To Wireless Camera