BJM Pumps SX75CSSF-575T - Manual (Page 4)

4
INTRODUCTION
This Installation, Operation and Maintenance manual provides important information on
safety and the proper inspection, disassembly, assembly and testing of the BJM
Pumps® S-F & SX-F Series submersible pump. This manual also contains information
to optimize performance and longevity of your BJM Pumps submersible pump. The F
Series
FARHRENHEIT ™ pumps are engineered to pump water based liquids up to 200°
Fahrenheit (93°C).
The submersible S-F Series pumps are designed to pump water and wastewater.
The SX-F Series pumps are designed to pump corrosive liquids in concentrations
chemically compatible with 316SS and FKM. The S-F & SX-F Series pumps are not
explosion-proof. They are not designed to pump volatile or flammable liquids.
Note: Consult chemical resistance chart for compatibility between pump
materials and liquid before operating pump. Consult BJM engineering if there is a
question on chemical compatibility.
If you have any questions regarding the inspection, disassembly, assembly or testing
please contact your BJM Pumps distributor, or BJM Pumps, LLC.
BJM Pumps, LLC
123 Spencer Plain Rd
Old Saybrook, CT 06475, USA
Phone: 877-256-7867
Phone: 860-399-5937
Fax: 860-399-7784
Information, including pump data sheets and performance curves, is also available on our web
site:
www.bjmpumps.com
For assistance with your electric power source, please contact a certified electrician.
Please pay attention to the following alert notifications. They are used to notify operators and
maintenance personnel to pay special attention to procedures, to avoid causing damage to the
equipment, and to avoid situations that could be dangerous to personnel.
NOTE: Instructions to aid in installation, operation, and maintenance or which clarify a
procedure.
Immediate hazards that WILL result in severe personal injury or death.
These instructions describe the procedure required and the injury which will result from failure
to follow the procedure.
Hazards or unsafe practices that COULD result in severe personal injury
or death. These instructions describe the procedure required, and the injury which could result
from failure to follow the procedure.
Hazards or unsafe practices which COULD result in personal injury or
product or property damage. These instructions describe the procedure required and the
possible damage which could result from failure to follow the procedure.