BJM Pumps PGV220-575T - Manual (Page 6)

6
Transportation, installation, wiring, operation, maintenance, and inspection should be
performed only by authorized and qualified personnel.
INSPECTION
Review all safety information before servicing pump.
• Do not exceed rated specifications for use; a submersible pump should
not be used on land. Failure to observe this caution may cause electric
shock, injury to a person or damage to the product.
• Do not use pump if damaged in anyway.
• Any modifications of the product made by the user shall void guarantee.
• Do not remove the nameplate.
TRANSPORTATION
During transport, care must be taken to avoid dropping or overturning the pump.
Failure to observe this caution may cause injury or damage to the product.
When lifting the pump, be sure to lift it using its lifting rings or handle.
• Do not lift a pump with machine connected, using only the lifting rings of
the pump. Failure to observe this caution may cause injury or damage to
the product.
• Do not lift by cables. Failure to observe this caution may cause injury or
damage to the product.
RECEIVING
Open packing after confirming that pump is right side up. Failure to observe this caution
may cause injury.
Verify that the received pump is the one you ordered. Installing the wrong product can
cause unwanted results, and damage to the product.
The following are recommended installation practices/procedures for the pump. If there
are questions in regards to your specific application, contact your local BJM Pumps
distributor or BJM Pumps, LLC.
PRE-INSTALLATION INSPECTION
1) Check the pump for damage that may have occurred during shipment.
2) Inspect the pump for any cracks, dents, damaged threads, etc.
3) Check power cord (and seal minder cord, if installed) for any cuts or damage.
4) Check for, and tighten any hardware that appears loose.