BJM Pumps KB110H-575T - Manual (Page 25)

START-UP REPORT FORM
presence?
Are guide rails exactly vertical? Yes No
Is base elbow installed level? Yes No
Liquid level controls: Model
Is control installed away from
turbulence?
Yes No
Operation Check
Tip lowest float (stop float), all pumps should remain off.
Tip second float (and stop float), one pump comes on.
Tip third float (and stop float), both pumps on (alarm on simplex).
Tip fourth float (and stop float), high level alarm on (omit on simplex).
If not on levels controls, describe type of controls
Does liquid level ever drop below
volute top?
Yes No
Control Panel MFG & model no.
Number of pumps operated by control panel
NOTE: At no time should hole be made in top of control panel, unless proper sealing
devices are utilized.
Short Circuit protection:
Type:
Number and size of short circuit device(s) Amp rating:
Overload type: Size: Amp rating:
Do protective devices comply with
pump motor amp rating? Yes No
Are all pump connections tight? Yes No
Is the interior of the panel dry? Yes No
If No, correct moisture problem.
Electrical readings
SINGLE PHASE
Voltage supply at panel line
connection, pump off
L1 L2
Voltage supply at panel line
connection, pump on
L1 L2
Amperage load connection, pump on L1 L2
THREE PHASE
Voltage supply at panel line connection, pump off
L1-L2 L2-L3 L3-L1