Flowline LV55 FloaTek - Manual (Page 12)

12 of 12 Float-Tek LV55 Series 17 SEPT 08
MN201345 Rev A
Cleaning procedure:
1. Power: Make sure that all power to the transmitter, controller and/or power supply is
completely disconnected.
2. Transmitter removal: If necessary, make sure that the tank is drained well below the
switch prior to removal. Carefully, remove the transmitter from the installation.
3. Cleaning the switch: Using a soft bristle brush and mild deter-gent, carefully wash the
switch. Do not use harsh abrasives such as steel wool or sandpaper, which might damage
the surface of the sensor. Do not use incompatible solvents, which may damage the
sensor's 316 SS body. Take particular care to remove any scaling from the float body and
make sure that it moves freely.
4. Transmitter installation: Follow the appropriate steps of installation as outlined in the
Installation section of this manual.