Flowline LU84-5161 EchoSpan - Manual (Page 12)

12 of 22 EchoSpan 31 MAR 11
MN301550 Rev B
o Note: if UNITS is set to Percent, then TANK will not appear. To view TANK, set UNITS
to any of the following: Inches, Centimeters, Feet or Meters.

SAFE – The fail-safe for the EchoSpan can be preset to the customer’s requirement.
o 22 mA – Overfill fail-safe setting.
o 21 mA – Overfill fail-safe setting.
o 20 mA – Full fail-safe setting.
o 4 mA – Empty fail-safe setting.
o HOLD – Keeps the output at its last current reading when fail-safe condition occurs.

TG CAL – Target Calibration (allows for the sensor to accept the current level as either EMPTY
or FULL.

VALUES – Provides setup information, the ability to reset the EchoSpan and a simulation mode
to test the relay function.
o SETUP – Will display the setting for all functions of EchoSpan.
o DIAG – This is a production test feature used by the factory to confirm operation. This
mode should only be used when supervised by a Flowline representative.
o RESET – Will reset the EchoSpan back to its original factory setting.

HELP – Provides information for contacting Flowline no-line.

RUN – Returns the unit to normal measurement and control mode.
How to enter the MENU:
1. Press and hold SELECT key (approximately 5 seconds) until MENU is displayed.
2. The menu items will rotate through display.
3. Press SELECT to change an item.
How to configure UNITS:
1. In the MENU mode, press select when UNITS is
display.
2. Press SELECT to choose between INCHES, CM
(centimeter), FEET, METERS or PERCENT.
3. Select EXIT to return to the Top Level Menu.