Flowline LU29 EchoSonic II - Manual (Page 3)

3
Configuring the EchoSonic® II
Configuration of your sensor should be performed prior to mounting, since it requires
connection to your PC.
Step 1: Install the WebCal™ Software
Download WebCal™ from
www.flowline.com onto a PC with the following minimum
specifications:
Windows
®
2000/XP/Vista/7/8, 10 MB storage space, 256 MB RAM, 1 USB 2.0 port
Double‐click the WebCal™ icon to install before proceeding to Step 2. You must have an
active Internet connection to install WebCal™, as it will automatically verify driver updates.
Step 2: Connect the USB Fob
NOTE: Do not connect the Fob until after you’ve installed WebCal™.
The sensor communicates to its configuration software through the USB Fob. Prior to
connecting the Fob, ensure that all external power is disconnected from the EchoSonic® II
as power is provided through the PC’s USB 2.0 port. Do not use a cable connecting the
sensor to the Fob any longer than 15 feet.
1) Connect the red, green, white, and black wires from the EchoSonic® II to the
corresponding colored terminals on the Fob (as shown in the diagram).
2) Tighten the terminal screws with a slotted screwdriver.
3) Plug the Fob into your PC’s USB port.