EXP Computer ThinCD E series for CDE-2440(PCMCIA Model), CDE-2450(USB Model), CDE-2465(Parallel Model) - Manual (Page 8)

8
5. Audio Line-Out Jack:
Send audio signal to an external amplifier.
Power Source
USB Interface:
This ThinCD drive model can be powered by the AC Adapter only.
*Make sure the Power Source Switch is set at DC, located on the rear panel.
PCMCIA Interface:
This ThinCD drive model can be powered by either the AC Adapter or
directly from the computer via the PCMCIA slot.
* Make sure the Power Source Switch, located on the rear panel, is set to
PC.
Parallel Cable Interface:
This ThinCD drive model can be powered by the AC adapter only.
*Make sure the Power Source Switch is set at DC, located on the rear panel
Only use the AC adapter provided with this unit. Using an incorrect
AC adapter may cause permanent and unpredictable damage to the
Portable CD-ROM drive.
System Requirements
USB Model:
• A computer with an enabled USB 1.1 port
• Windows 98, 2000
PCMCIA Model:
• A computer with a Type II or Type III Card slot
• DOS, Windows 95, 98, 2000 or NT
Parallel Cable Model:
•
A computer with a Parallel Port
•
DOS, Windows 95, 98, 2000 or NT