EXP Computer HD Traveler - Manual (Page 15)

Click on the “Advanced”
• Click the “MS-DOS mode” Click on “Specify a new MS-DOS
configuration”
•
Click on “OK”. Then
click on “OK”. This is
the end of the DOS
mode icon setup.
•
The Next step is to configure the DOS mode session for the DOS drivers
that are needed to run the Hard disk/game card.
• If you have a config.dos and autoexec.dos file on the “C” drive. Just put
the lines that are missing in the corresponding boxes. If you do not have
these files just continue without it. This just means that certain devices
may not function without first loading the DOS drivers for this DOS
mode session.
• Double click on the new icon.
•
Click on “YES
•
Once the computer is started in this mode, you can then install the DOS
HD Traveler drivers.
•
Run the Installation program for the DOS drivers from EXP’s disk.
•
More detailed instructions on “SOFTWARE INSTALLATION FOR
DOS/WINDOWS 3.1” can be found under ‘Automatic installation’
•
To restart Windows 95 normally, type in EXIT at the command prompt
and press “Enter”.