EXP Computer CD Traveler Plus - Manual (Page 18)

- - 18
INSTALLATION FOR PARALLEL PORT INTERFACE
HARDWARE INSTALLATION
Before you begin, make sure you turn OFF all power to your system before
connecting the CD-ROM to your computer.
1. Connect the DC Input adapter cable to the EXP CD-ROM drive
assembly.
2. Connect one end of the Parallel cable to EXP CD-ROM (26 pin small
connector), and connect the other end to computer parallel port.
(standard 25 connector)
3. Plug-in the AC adapter to a working AC receptacle.
4. Turn on the power of CD-ROM before turn on the computer.
You are now ready to install the software.
WARNING
SOFTWARE INSTALLATION FOR WINDOWS 95/98
From the Desktop Click ‘My Computer’ icon, ‘Control Panel’ and then ‘Add
New Hardware’ Click "Next>" to begin.
1. When prompted whether to search for your new hardware,
The CD and electronic components installed on the CD-ROM are very sensitive
to damage from static electricity. Before handling the unit, touch a grounded
metal surface. DO NOT connect/disconnect the CD-ROM
unit to/from the
parallel cable when the system is in power-on state.