EXP Computer Bluetooth: iPAQ H3850 - Manual (Page 3)

• Using the registry editor, verify the actual COM port that is assigned to the CF Bluetooth
Adapter
• If the port was COM5, leave the registry file intact. Otherwise, correct the registry file.
• ActiveSync the registry file to your iPAQ 3850 and use your registry editor to import it.
• Soft reset the iPAQ
• Attempt to run CEDemoExplorer.
If CEDemoExplorer runs successfully, then your device is working properly and you will be
ready to begin using your BTW-CE software and DK.
4. Reconfiguring your Device
This problem is due to the fact that the iPAQ 3850 assigns a different COM port to the
CF Bluetooth Adapter than the other iPAQ models.
4.1 [O
PTIONAL
] H
ARD
R
ESET YOUR
P
OCKET
PC D
EVICE
These instructions assume that you are starting with no BTW-CE software installed on your
Pocket PC device. You may want to hard reset your device in order to remove any previous
software that might interfere with this procedure. This step is entirely optional. See the figure
in section 4.9 for information on how to perform a hard reset.
WARNING: A hard reset will remove all software that you have previously installed
on your Pocket PC device.
4.2 I
NSTALL BTW-CE (I F NOT A LREADY I NSTALLED )
If you performed a hard reset as specified in the preceding step, you will need to reinstall your
BTW-CE software and should do so now. If you have not already installed the BTW-CE
software, do so now.
4.3 Instructions on making Bluetooth CF card work on BTW (Bluetooth software
for Windows)
1. Insert Bluetooth CF card in notebook, install driver for OX16CF950. Driver can be found in
v.392 folder.
2. Install BTW on notebook.
3. After installation is complete, click Yes to reboot.
4. Double click on “billionton_cf_windows.reg” to add registry entries to Windows registry.
5. From Device Manager, find out which COM port is used by OX16CF950, e.g. OX16CF950 is
using COM5.
6. Run regedit, go to HKLM/Software/Widcomm/BTConfig/LocalDevice/PortNumber and make
sure the entry value is set for COM5
7. Save changes, close regedit.
8. BTW for Bluetooth CF should work now.
4.4 Instructions on making Bluetooth CF card work on BTW-CE (Bluetooth
software for Windows CE)
1. Insert Bluetooth CF card in PDA, install BTW-CE.
2. Install regedit for Windows CE
3. After installations are complete, soft reset PDA.
4. Run “Registry Editor” and add the following registry entries manually.
5.1-Please remove the CF card and soft reset the PDA
5.2 -Rename or delete this registry entry from the registry:
HKLM/Drivers/PCMCIA/CF_CARD-GENERIC-A569
. to for example: HKLM/Drivers/PCMCIA/zzCF_CARD-GENERIC-A569
5.3 – Change entries to match:
5. Close Registry Editor to save changes.