eLine Technology VDM_‐VDM‐IR User Manual User Manual
Page 6
ANALOG CAMERA ELI‐VDM USER MANUAL
eLineTechnology.com
Page | 6
2. Make connections through the opening in the wall or ceiling. (See connection instructions
below)
3. Attach the camera with screws to the optional surface mount bracket or directly to the wall or
ceiling. Attach the treaded dome cover by rotating it clockwise until tight.
4. Secure the dome cover to the camera by tightening the lock screw with an Allen wrench.
Caution: Once power is supplied, do not remove the camera from the mounting base due to risk of
electrical shock.
Adjusting the Lens
1. Loosen the lock screw with an Allen wrench.
2. Remove the dome cover by unscrewing it counter‐clockwise.
3. Loosen the two Phillips‐head screws on each side of the camera.
4. Adjust lens position. Tighten screws. Replace dome cover. Tighten lock screw.