The burner is operating but the radiators are cold, The domestic hot water does not appear hot enough – DE DIETRICH SOLNEO SGC 24 SOL User Manual
Page 16

16
SGC 24 SOL
15/10/2009 - 300017555-001-C
6. Troubleshooting
6.3.2
The burner is operating but the radiators are cold
Air and water noise in the radiators
`
Bleed the radiators.
`
Top up the heating circuit with water.
`
If it is often necessary to top up the installation with water,
contact your fitter.
`
If the problem persists, consult your fitter.
The burner is operating but the radiators are cold
`
Check that the boiler heating pump is operating correctly.
`
If the problem persists, consult your fitter
6.3.3
The domestic hot water does not appear hot enough
Flow of water from the tap too high.
The higher the flow, the lower the temperature.
`
Reduce the flow from the hot water tap.
`
If several draw-off points are open at the same time, close one
or other of the points.
6.3.4
Hot water takes a very long time to reach certain draw-off points and not others
This is due to the length of the hot water pipes between the draw-off
points and the boiler.
The greater the length, the longer the time necessary for the hot
water to replace the colder water in the pipes.