DE DIETRICH ECODENS DTG 1300-24 ECO _ V-130 - Manual (Page 5)

5
11/09/09 - 300010111-001-B DTG 1300-24 Eco / V130
2. Safety instructions and recommendations
2 Safety instructions and recommendations
2.1 Safety instructions
DANGER
If you smell gas:
1. Do not use a bare flame, do not smoke, do not actuate electrical
contacts or switches ( doorbell, light, motor, lift, etc..).
2. Cut the gas supply.
3. Open the windows.
4. Evacuate the premises.
5. Call your fitter.
Depending on the settings of the appliance:
`
The temperature of the flue gas conduits may exceed 60°C.
` The temperature of the radiators may reach 85°C.
` The temperature of the domestic hot water may reach 65°C.
DANGER
If you smell flue gases:
1. Switch the appliance off.
2. Open the windows.
3. Evacuate the premises.
4. Call your fitter.
Do not neglect to service the appliance:
For completely safe and optimum operation, you must
have your boiler regularly serviced by an approved
installer.
2.2 Recommendations
The installation and the first start-up must be performed by a qualified
professional.
Only qualified professionals are authorised to work on the
appliance and the instalation.
` Regularly check the water pressure in the installation (minimum
pressure 0.8 bar, recommended pressure between 1.5 and 2
bar).
` Keep the appliance accessible at all times.
` Never remove or cover labels and rating plates affixed to the
appliance. Labels and rating plates must be legible throughout
the entire lifetime of the appliance.
„ Aeration
The air inlet into the premises must in no event be obstructed, even
partially.
„ Maintenance
The servicing and cleaning of the boiler and the sweeping of the flue
gas pipe and the bleed pot must be done at least once a year by a
qualified professional.
We recommend that you take out a maintenance contract.
„
Precautions against frost
The boiler is fitted with an antifreeze system. In the event of total
shutdown of the heating in winter which may lead to the danger of
freezing (switching off of radiators and current), we recommend using
a correctly dosed anti-freeze product to stop the heating water
freezing. Failing this, drain the installation completely (in all cases,
consult your fitter).