Asus Motherboard AP130-E1 - Manual (Page 76)

4-22 Chapter 4: BIOS Setup
EPP Version [1.9]
Allows selection of the Parallel Port EPP version. This item appears
only when the Parallel Port Mode is set to EPP. Configuration options:
[1.9] [1.7]
Parallel Port IRQ [IRQ7]
Configuration options: [IRQ5] [IRQ7]
PS/2 Mouse Support [Enabled]
Allows you to enable or disable support for PS/2 mouse. Configuration
options: [Disabled] [Enabled] [Auto]
4.4.4 IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press Enter if
you wish to configure the item.
IDE Configuration
IDE Channel Selection [Both]
S-ATA Running Enhanced Mode [Yes]
Configure S-ATA as RAID
[No]
IDE Detect Time out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host & Device]
Allows BIOS to enable or
disable the floppy drive
controller.
IDE Channel Selection [Both]
Allows you to select the IDE channel that you wish to enable.
Configuration options: [Disabled] [Primary] [Secondary] [Both]
S-ATA Running Enhanced Mode [Yes]
When set to Yes, allows you to configure the Serial ATA channel as a
tertiary IDE channel. Configuration options: [Yes] [No]
Configure S-ATA as RAID [No]
When set to Yes, allows you to configure the Serial ATA devices into a disk
array. Configuration options: [No] [Yes]