Arcam DV29 - Manual (Page 28)

DV29
E-28
E
n
g
li
s
h
DV29
E-29
Status codes
The following status codes are defined:
MSB CODES:
n Stand-by ‘0’ (0x30): The DV29 is in stand-by state.
n Disc loading ‘1’ (0x31): A disc is being loaded by the DV29.
n Tray open ‘2’ (0x32): The disc tray is open.
n No disc ‘3’ (0x33): There is no disc in the DV29.
n Stop ‘4’ (0x34): Play-back of the disc is stopped.
n Resume stop ‘5’ (0x35): The DV29 is in ‘resume-stop’ state.
n Play ‘6’ (0x36): The DV29 is playing the disc.
n Pause ‘7’ (0x37): The DV29 is in ‘pause’ state.
n Scanning ‘8’ (0x38): Fast/slow forward/rewind in progress.
LSB CODES:
n No menu ‘@’ (0x40): No player menu is open (DVD menus may be open).
n Setup ‘A’ (0x41): The set-up menu of the DV29 is open.
n Programme ‘B’ (0x42): The programme menu of the DV29 is open.
n Bookmark ‘C’ (0x43): The bookmark menu of the DV29 is open.
n Search ‘D’ (0x44): The search menu of the DV29 is open.
n Trim ‘E’ (0x45): The trim menu of the DV29 is open.
n PLII ‘F’ (0x46): The Pro Logic II menu of the DV29 is open.
Example command and response sequence
As an example, the command to be set the front-panel display of the DV29 to ‘dimmed’ (defined below)
is as follows:
STR CC P1 P2 ETR
! + 1 ~ (0xD)
Assuming that the command was accepted by the DV29, the DV29 shall respond to this command with
the following sequence:
STR RC AC P1 P2 P3 ETR
! + @ 1 ~ ~ (0xD)