BEI Sensors Heavy Duty Inclinometers - Manual (Page 5)

Page 5 Datasheet_INC-360-1-S102-VH2-PM Version 130710
HEA VY DUT Y INCLI NO MET E R 360°
SYNCHRONOUS S E RIAL I NT E RFA CE ( S SI)
Electrical Connection
The inclinometer is connected via an 8 pin M12 A-coded round connector (male side at sensor).
Pin Function
1 GND
2 Supply Voltage
3 SSI Clk+
4 SSI Clk-
5 SSI Data+
6 SSI Data-
7 Preset
8 Counting Direction (Complement)
Preset Function
Voltage Level Function
0 (Input = N.C. or GND) Inactive
1 (Input

4.5V / Input

Supply
Voltage)
Preset is activated
1
. The inclinometer value will be set to 0 in
the moment the Preset Level will change to inactive again
(falling edge)
Input Resistance 110 kOhm
1) The Preset needs to be activated for at least 1s before the falling edge will be detected.
Counting Direction / Complement Function
Voltage Level Inclinometer counting direction for clockwise rotation
(Cap Facing Towards Viewer)
0 (Input = N.C. or GND) Down
1 (Input

4.5V / Input

Supply
Voltage)
Up
Input Resistance 110 kOhm
The inclinometer value is inverted after the Complement level is activated