American Audio CDI-500 - Manual (Page 8)

CAUTION:
• The LCD is designed to be clearly visible within the angles shown in
Figure 2. Mount the control
unit so that the visual angle is within this range.
1. Checking the Contents
Be sure your CDI-500 Mp3™ was shipped with the following:
1) CDI-500 Mp3™ Professional CD player.
2) Operating instructions (this booklet).
3) One (1) set of RCA cables.
4) One (1) 1/8” mini plug.
5) Warranty card.
2. Installing the Units
Place your unit on a flat surface or mount it in a flat surface case
3. Connections
1) Be sure the power is disconnected.
2) Connect the included RCA cable from your CDI-500 Mp3™ outputs to the inputs on your
mixer.
3) Use the supplied 1/8” mini plug cable to connect your CDI-500 Mp3™ to a mini jack
connection (A or B ) on a compatible American Audio® or American DJ® “Fader Q Start”
mixer. (This will enable the Fader “Q” Start function)
CAUTION:
• Be sure to use the supplied mono 1/8" control cables. Using other types of cable may result
in unit damage
• To avoid severe damage to the unit, be sure the power is off when making connections to
the unit.
SET-UP
CAUTION:
• The player will work normally when the main unit is mounted with the front panel within 15
degrees of the vertical plane If the unit is tilted excessively, discs may not be loaded or unloaded
properly.
(Figure 1)
Figure 1
15˚
Figure 2
© American Audio ® - www.AmericanAudio.us - CDI-500 Mp3™ Instruction Manual Page 8
FOR BEST CD-R DISC PLAYBACK RESULTS IN THIS CD PLAYER PLEASE FOLLOW THESE
GUIDELINES:
1. High quality CD-R Audio discs (should conform to the standards of the Orange Book 2).
2. Use a high quality bit rate when recording discs. (At least 160kbps)
3. Record discs in the slowest speed possible. (i.e. 2x or 4x speed)
50˚ 10˚