C-Squared CO Analyzer Manual User Manual
Page 4
Carbon Monoxide Analyzer Manual
Page 4
C-Squared Inc. 1440 S State College Blvd, Unit 4L, Anaheim, CA 92806
Tel: (714) 999-2791, Fax: (714) 999-2928,
Sensor Replacement:
a) Remove the sensor from the case by removing the back cover of the analyzer as
noted for battery replacement and disconnecting the Molex connector
b) Dispose of the sensor in accordance with local regulations.
c) Remove the new sensor from its package; check it for leaks or any damage.
d) Be sure to remove the shorting plug from the connector prior to installing it into the
Analyzer.
Care of the Analyzer:
The Analyzer is an electronic instrument and should be treated as such. It is a completely
sealed unit and the enclosure was designed to withstand use in harsh environments. However
it should not be intentionally dropped in water or physically abused. With proper care it will
provide you with a long life. The Analyzer and sensor may be wiped clean with standard
disinfectants or water. The Analyzer is designed to be splash proof so there is little chance of
liquids coming in contact with delicate electronics.
Safety:
When the batteries or sensor require replacement, dispose of them in accordance with local
regulations.
The sensor contains a KOH (Potassium Hydroxide) solution that is hazardous and can result in
the following:
Eye:
Can cause eye damage. Flush the eye with water for 15 minutes and
seek aid.
Ingestion:
Can be serious if swallowed. Drink a lot of fresh water and seek aid.
Skin:
Chemical burn is possible. Wash the area of skin exposed and remove
any clothing that was in contact with the KOH. Seek aid if necessary.
V:03/08/01