CHIEF KTA1003 - Manual (Page 4)

KTA1003 Installation Instructions
4
Figure 3
6. Install two square nuts (D) into array channel and position
at approximate mounting location of second base.
(See Figure 4)
NOTE: Chamfered side of square nuts should be facing pole.
7. Install end lock into array channel and secure to array
channel using retaining screw. (See Figure 4)
NOTE: Step 7 only applies when adding an additional base to
one existing array.
Figure 4
8. Align outer mounting holes in front array attachment bracket
(A) with two square nuts (D) in array channel(s) and secure
using two flat washers (E) and two button head cap screws
(G). (See Figure 5) and (See Figure 6)
NOTE: DO NOT tighten at this time!.
Figure 5
Figure 6
9. Assemble pole to base following the instructions provided
with the accessories.
10. Align pole of new base assembly with new array attachment
bracket . (See Figure 7)
11. Install two button head cap screws (F) and two flat washers
(E) through pole clamp (B) and into array attachment
bracket (A). (See Figure 7) and (See Figure 8)
Figure 7
12. Secure pole clamp (B) to array attachment bracket (A) using
hex wrench (C) provided. DO NOT fully tighten at this time!
(See Figure 8)
Cable Management Clip
(D) x 2
Array
Array
End Lock
Square Nut
Array
(A) x 1
(E) x 2
(G) x 2
(D) x 2
(A) x 1
(C) x 1
Array
(E) x 2
Array
(B) x 1
(F) x 2
(A) x 1