CHIEF K1C Series - Manual (Page 17)

Installation Instructions K1C Series
17
Pivot Adjustment Range
Single Arm Models
1. Adjust arm angle as desired up to 90 degrees in either
direction. (See Figure 24)
WARNING: Swinging the arm beyond 90 degrees may
result in the mount slipping off the desk causing serious
injury!
Figure 24
Dual Arm Models
1. Adjust arm angles as desired within a 90 degree range from
the pivot point of the arm and a perpendicular centerline of
mount. (See Figure 25)
WARNING: Swinging the arm beyond this range may result
in the mount slipping of the desk causing serious injury!
Figure 25
Cable Management
1. Press insides of cable management covers at both ends to
unhinge tabs on either end of cable management cover on
upper arm. (See Figure 26)
2. Lift cable management cover up until tabs are unhinged and
cover is in the “open” position. (See Figure 26)
Figure 26
Figure 27
3. Route cables through cable management channels. (See
Figure 27)
IMPORTANT ! : Be sure to leave enough slack in the
cables near display and arm joint to allow for full arm
articulation!
4. Close cable management covers on monitor arm. (See
Figure 27)
5. Repeat Steps 1-4 for lower arm.
(top view)
+/- 90 degrees range
of motion
pivot point of the arm
perpendicular centerline 90 degrees range
of motion per arm
pivot point of the arm
(top view)
cable management cover tabs
1
2
2
2
4
4
3
3
cable (typical)