CHIEF K1C Series - Manual (Page 16)

K1C Series Installation Instructions
16
Adjustments - K1C22H models only
Display Adjustments
1. Loosen knobs securing faceplates to array. (See Figure 22)
2. Slide displays laterally on array to adjust lateral shift. (See
Figure 22)
3. Adjust pitch and pivot position as desired. (See Figure 22)
4. Tighten knobs to secure faceplates in position. (See Figure
22)
Figure 21
Array Bar Roll Adjustment
1. Loosen roll adjustment screws on back of array bracket.
(See Figure 22)
2. Adjust roll of array bar as desired. (See Figure 22)
3. Tighten roll adjustment screws on back of array bracket.
(See Figure 22)
Figure 22
Display Removal
WARNING: Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! (See
Figure 23)
1. Make sure display is in the upright position.
2. Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 23)
Figure 23
2
3
2
1 4
3
3
3
1 3
2
2
quick release tab
2