CHIEF K1C Series - Manual (Page 13)

Installation Instructions K1C Series
13
Display Installation
NOTE: For K1C120BXI2 mounts, refer to FSBI2B installation
instructions to install iPad® to mounting arm.
1. Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 11)
Figure 11
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the K1C Series Monitor Arm
up to (and including) the display does not the weight limits
listed in the table below. Use with products heavier than the
maximum weight indicated may result in collapse of the
mount and its accessories causing possible injury.
2. Carefully place display face down on protective surface.
3. Connect faceplate to display
For flush mounting hole installation:
• Using Phillips screwdriver, carefully install four
M4x14mm screws (B) through corresponding
holes on faceplate and into the mounting holes on
the display. (See Figure 12)
Figure 12
MODEL Max Weight
Allowed for EACH
Display Max Weight
Capacity of
Mounting System
K1C110 22 lbs
(9.98 kg)
22 lbs
(9.98 kg)
K1C120 22 lbs
(9.98 kg)
22 lbs
(9.98 kg)
K1C120BI2 2 lbs
(0.9 kg)
2 lbs
(0.9 kg)
K1C210 22 lbs
(9.98 kg)
44 lbs
(19.96 kg)
K1C220 22 lbs
(9.98 kg)
44 lbs
(19.96 kg)
K1C120SXF1 22 lbs
(9.98 kg)
22 lbs
(9.98 kg)
K1C210SXF1 22 lbs
(9.98 kg)
44 lbs
(19.96 kg)
quick release lever 1
1
K1C220SXF1 22 lbs
(9.98 kg)
44 lbs
(19.96 kg)
K1C22H 9 lbs
(4.08 kg)
18 lbs
(8.16 kg)
K1C22HSXF1 9 lbs
(4.08 kg)
18 lbs
(8.16 kg)
MODEL Max Weight
Allowed for EACH
Display Max Weight
Capacity of
Mounting System
(B) x 4
quick release
faceplate
(for flush mounting holes)
3