CHIEF K1C Series - Manual (Page 15)

Installation Instructions K1C Series
15
Adjustments
Pitch Adjustment (non-array models)
1. Adjust pitch to desired tilt position. (See Figure 17)
2. Adjust pitch tension screw to change the adjustment
tension. (See Figure 17)
Pivot Adjustment (non-array models)
3. Adjust pivot position as desired. (See Figure 17)
4. Use 3/16” hex key (P) to adjust pivot point tension screws to
change pivot adjustment tension. (See Figure 17)
Figure 17
Rotational Adjustment
NOTE: (Optional) Rotational adjustment may be locked by
installing rotational locking screw (K) into back of
faceplate. (See Figure 18)
Figure 18
5. The monitor may be adjusted 90 degrees in either direction
in order to provide a portrait view of the monitor. (See Figure
17)
6. Use 3/16” hex key (P) to adjust rotational adjustment screw
to adjust rotational tension. (See Figure 17)
Lift Arm Tension Adjustment
1. Use 3/16” hex key (P) to adjust lift arm tension adjustment
screw. (See Figure 19)
Figure 19
NOTE: Tension may also be adjusted with upper tension
adjustment screw inside cable management cover and
1/8” hex key (Q). (See Figure 20)
Figure 20
pitch
pivot point
tension
tension
5
1
3
Rotational tension
(K)
K1C110
K1C120
1
Reduce tension
Increase tension
(lighter display)
(heavier display)
DO NOT
over-tension adjustment
tension screw.
underside view
Reduce tension
Increase tension
(lighter display)
(heavier display)
Do NOT over-tension
adjustment tension
screw.