CHIEF FSRV_FSR4100 - Manual (Page 6)

FSRV / FSR4100 Installation Instructions
6
5. Gently tap two anchors (B) into anchor holes. Anchor barbs
should be fully engaged in drywall. (See Figure 3) and (See
Figure 4)
Figure 3
Figure 4
6. Using Phillips screwdriver, tighten anchor screw until
anchor has fully collapsed against back side of drywall.
(See Figure 4)
NOTE: Anchor screw will feel tight until anchor begins to
collapse. Screw will then turn easier for many turns.
Screw will feel tight when anchor has fully collapsed.
7. Remove and retain anchor screws from anchors (B).
NOTE: Anchors (B) may come with small washers which may
be left on the screw or discarded. These small washers
do NOT replace #10 washers (C).
8. Insert anchor screws through two #10 washers (C), FSR
assembly (A) and install into collapsed anchors (B). (See
Figure 5)
9. Install two #10 x 2 1/2” Phillips tapping screws (D) through
two #10 washers (C), FSR assembly (A) and into wood
stud. (See Figure 5)
Figure 5
Install Display to Mount
NOTE: Attach proper interface bracket to display following
instructions included with interface bracket.
• FSRV includes the FSBV interface bracket.
• FSR4100 includes the FSB75100 interface
bracket.
1. Open latching flag by rotating flag clockwise on FSR
assembly (A). (See Figure 6)
Figure 6
(B) x 2
Drywall
Anchor barb
Anchor Anchor not
collapsed
collapsed
(D) x 2 9
8 anchor screws x 2
(C) x 2
(C) x 2
(A)
1
Latching
flag closed
Latching
flag open