CHIEF FSRV_FSR4100 - Manual (Page 5)

Installation Instructions FSRV / FSR4100
5
INSTALLATION
The FSRV/FSR4100 may be installed either centered on a
single wood stud, or not centered on a single wood stud if
anchored to drywall (1/2” minimum thickness) on the other side.
Install Mount Centered to Single Wood Stud
1. Determine approximate mounting location, keeping in mind
the display size.
2. Use a stud sensor to locate applicable wood stud. Mark
location with a pencil.
3. Level FSR assembly (A) at desired height and, using it as a
template, mark the location of upper and lower pilot holes.
Ensure marks are in the center of wood stud.
NOTE: Mount can provide ±1/2” of lateral shift by using mount
holes on either side of vertical center line.
WARNING: ELECTRICAL SHOCK HAZARD! Drilling into
electrical wires or cables can cause DEATH or SERIOUS
PERSONAL INJURY! ALWAYS make certain area behind
mounting surfaces is free of electrical wires and cables
before drilling or installing mount fasteners.
4. Drill pilot holes using a 1/8” drill bit. Ensure pilot holes are
straight.
5. Fasten FSR assembly to wood stud using two #10 x 2-1/2”
Phillips head screws (D) through two #10 washers (C), FSR
assembly (A), and drywall (not shown) and install into pilot
holes. (See Figure 1)
Figure 1
Install Mount to a Single Wood Stud and Drywall
WARNING: Drywall must have a minimum thickness of 1/2”
and a maximum thickness of 5/8”. Do not install drywall
anchors into the seam between drywall pieces.
1. Determine approximate mounting location, keeping in mind
the display size.
2. Level FSR assembly (A) at desired height and, using it as a
template, mark the location of the four anchor holes (one in
each corner slot). Two holes must be centered on a single
wood stud.
WARNING: ELECTRICAL SHOCK HAZARD! Drilling into
electrical wires or cables can cause DEATH or SERIOUS
PERSONAL INJURY! ALWAYS make certain area behind
mounting surfaces is free of electrical wires and cables
before drilling or installing mount fasteners.
3. Drill 1/8” pilot holes in wood stud locations. Ensure pilot
holes are straight.
4. Drill 3/8” anchor holes in the other two marked locations.
Ensure holes are straight and completely through drywall.
(See Figure 2)
Figure 2
2
4
x 2
x 2
5 (D) x 2
(A)
(C)
3 x 2
4 x 2
x 4 2
1/8”
3/8”