CHIEF MTMPU - Manual (Page 9)

Installation Instructions MTMPU
9
Adjusting Roll/Height of Wall Brackets
NOTE: The height adjust wall bracket allows adjustment of
+/-1/2”.
1. Use 3/16” hex key (F) to turn height-adjust screws to right
(tighten) to raise side of screen. (See Figure 10)
2. Use 3/16” hex key (F) to turn height-adjust screws to left
(loosen) to lower side of screen. (See Figure 10)
Figure 10
Adjusting Tilt of Upright Brackets
WARNING: IMPROPER TILT ADJUSTMENT MAY LEAD
TO DISPLAY TIPPING FORWARD CAUSING PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Hold display while
loosening upright bracket knobs.
1. Turn upright bracket knobs to left to loosen tilt. (See Figure 11)
2. Adjust tilt as required.
3. Lock at desired tilt by turning upright bracket knobs to right
to tighten. (See Figure 11)
Figure 11
Locking Mount (Optional)
Add padlock (not included) to upright bracket tab to lock the
MTMPU mount. (See Figure 12)
Figure 12
1 2
(Screen not shown for clarity)
Upright
bracket knob
1 3
(Screen not shown for clarity)
Add padlock
(Optional)